Hello Guest it is March 28, 2024, 01:53:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Dries

Pages: 1
1
General Mach Discussion / Mach3 plugins
« on: August 20, 2018, 02:41:15 AM »
Hi guys

I need some info regarding vector engraving please. I have a plasma table with mach3 for a while now, and are fairly familiar with the product. However, I now purchased a second hand laser machine which also run mach3 with the only plugin installed is TOMTOM, that can only do raster engraving.  Is there any other programs or plugins available that can be used to do vector engraving on this machine. I would prefer to keep mach3 as my cnc controller though. Looked everywhere, I could think of, but to no avail.
I hope this sense. Any advise will be appreciated. Thx

Pages: 1