1
General Mach Discussion / Mach3 DRO & toolpath NOT refreshing
« on: August 07, 2018, 06:26:45 AM »
Hi!
Few days now I have a little problem.
When I move to any axis the DROs and the toolpath screen not renewed. When I stop the movement then the DROs and toolpath screen jumps to the correct position. Even when I run a program (toolpath) they still frozen antil the job finish or I press RESET or Feed Hold. Then they jump again to the correct position. For some reson the g-code screen working right. It dosen't mater if I make the movemed via keyboard or pentant.
Any help!!!
Few days now I have a little problem.
When I move to any axis the DROs and the toolpath screen not renewed. When I stop the movement then the DROs and toolpath screen jumps to the correct position. Even when I run a program (toolpath) they still frozen antil the job finish or I press RESET or Feed Hold. Then they jump again to the correct position. For some reson the g-code screen working right. It dosen't mater if I make the movemed via keyboard or pentant.
Any help!!!