Hello Guest it is March 29, 2024, 09:14:27 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cnc jim

Pages: 1
1
General Mach Discussion / usual hard drive swap problems.
« on: July 11, 2018, 02:38:25 PM »
So the hard drive failed but I got the Mach 3 folder copied onto a thumb drive.
With new hard drive installed I copied the folder on the desk top and clicked on the shortcut. All seemed to load as normal, but although the DRO's move the motors don't.
I am on XP pro, I have recent .xmls, I guess it's something simple, but what?
thanks in advance guys..
always panic when this happens, but it's been 4 years so...
i have of course searched the forum

Pages: 1