Hello Guest it is March 28, 2024, 06:07:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Lee1966

Pages: 1
1
General Mach Discussion / What have I done!
« on: June 17, 2018, 01:21:37 AM »
Aloha,

 I am switching from Linuxcnc to Mach3 and have done something stupid. Loaded Mach3 on a fresh non-updated windows 7 32 bit. Got everything (X, Y+B,  Z, A, stops and Probe.) working pretty good. While referencing all, the y+b was moving in the wrong direction. I went into the homing settings and checked the reversed and not the negative direction. Then I tried to ref all again. Now all my motors just chatter and move at about the slowest speed possible. They seem to be moving back and forth more than in a direction. But the are going in the right direction.
I deleted Mach3 and all the related folders and files from my pc and rebooted and reloaded Mach3. I set up a new mill profile but it is still doing the same thing. The Nema 23's  wont even move at all in the motor tuning screen but they do chatter and step in the right directions (ever so slowly) with Gcode or keyboard and tab control flyout. The DRO's operate at the correct speed.
What have I done? :-\
Thanks for any help you might give

Lee

Pages: 1