Hello Guest it is November 12, 2019, 06:27:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Keldar

Pages: 1
1
Newfangled Mill Wizard / Mill Wizard Feed Rate
« on: June 08, 2018, 10:28:25 PM »
I have a question about the feed rate that the wizard puts out. Everything looks good except it inserts a feed rate equal to the plunge rate just before the main G code. I have attached an example of the code. It is easy to fix just by editing it out but I wonder why it puts it there. Thank you for any insight on this.

Pages: 1