1
General Mach Discussion / Mach 3 outputs 15hz to vfd instead of 0
« on: July 11, 2019, 02:43:50 PM »
Hello there,
i am using mach 3 which is talking to my VFD via the Controller card. Everything was ok until today. now when i set the RPM to 0 in mach 3 and when i press F5 to start the spindle the minimum Hz is 15. It doesnt go below that. I dont really know what the problem is. I tried the synch spindle feature but things got worse instead of better. I am driving it with 0-10 Volts signal. When i switch off the mach 3 control and use the potentiometer and the VFDs own start/stop button, then everything is ok. 0 corresponds to 0. It seems that it needs to be set up in mach 3 somehow?
i am using mach 3 which is talking to my VFD via the Controller card. Everything was ok until today. now when i set the RPM to 0 in mach 3 and when i press F5 to start the spindle the minimum Hz is 15. It doesnt go below that. I dont really know what the problem is. I tried the synch spindle feature but things got worse instead of better. I am driving it with 0-10 Volts signal. When i switch off the mach 3 control and use the potentiometer and the VFDs own start/stop button, then everything is ok. 0 corresponds to 0. It seems that it needs to be set up in mach 3 somehow?