1
General Mach Discussion / Need help on homing machine
« on: May 30, 2018, 12:07:52 AM »
Hi, this may sound stupid but I really need help,
Whenenver I press refer to home, it will home the z first and when it comes to x and y ,
when it touches the homing switch on Y it will back down, but unlike the Z axis it won't stop backing until it reach the end of the table , same thing will happen with the x axis
so in order for it to stop , I'm manually lighting up the switches by using a metal.
I can still use the machine , I'm not able to figure out how I can remedy this.
Thanks for any help.
Whenenver I press refer to home, it will home the z first and when it comes to x and y ,
when it touches the homing switch on Y it will back down, but unlike the Z axis it won't stop backing until it reach the end of the table , same thing will happen with the x axis
so in order for it to stop , I'm manually lighting up the switches by using a metal.
I can still use the machine , I'm not able to figure out how I can remedy this.
Thanks for any help.