1
General Mach Discussion / Latest update gives probem with Shuttle Express
« on: May 29, 2018, 05:43:59 AM »
I went to use my router this morning and found Mach3 wouldn't start. This proved to be the Windows 10 update problem, so I installed the latest version of Mach3, and it now starts up OK.
However, I have a problem with the Shuttle Express on this version. The outer jog dial starts the axes moving OK, but they do not stop when the dial is centred. To stop them I have either to hit the reset button, or to operate the jog dial in the opposite direction.
There is a secondary difference in that there is no longer any audible feedback when I press one of the button on the Express that I use to select an axis. This is less important, though the audible feedback is nice.
I have tried with and without the Shuttle drivers installed, and it makes no difference.
Hoping someone will have an idea of what the problem is, and thanks in advance for any assistance,
Rgds, Andy
However, I have a problem with the Shuttle Express on this version. The outer jog dial starts the axes moving OK, but they do not stop when the dial is centred. To stop them I have either to hit the reset button, or to operate the jog dial in the opposite direction.
There is a secondary difference in that there is no longer any audible feedback when I press one of the button on the Express that I use to select an axis. This is less important, though the audible feedback is nice.
I have tried with and without the Shuttle drivers installed, and it makes no difference.
Hoping someone will have an idea of what the problem is, and thanks in advance for any assistance,
Rgds, Andy