1
General Mach Discussion / X and Y Alignment
« on: May 04, 2018, 07:42:38 PM »
As I am extremely new to this, I have to be very careful, and try to use the right language to describe the problem I am experiencing....otherwise you will be more confused than me
I have my work piece located on the bed, touched off and set the ZERO for all three Axis.
However, when I load my simply GCODE - the table view show the work piece with an approx offset in -8mm in Y and -3mm in X
I have my work piece located on the bed, touched off and set the ZERO for all three Axis.
However, when I load my simply GCODE - the table view show the work piece with an approx offset in -8mm in Y and -3mm in X