1
Mach4 General Discussion / Carving comes out 4 inches off center
« on: July 01, 2021, 04:41:12 PM »
I'm putting this problem in Art Soft because I don't know where the problem originates from. I'm using the center of the project as the center point and the carving starts out well but then the spindle shifts about 4 inches off center and continues. If I allow it to run its course it does the rest of the carving 4 inches off center. I cannot tell where the problem is. I'm using mach4 ver. 4.2.0.3461 the machine is home built and I have been using it for about 4 years.
Thank you in advance
Thank you in advance