Hello Guest it is October 20, 2021, 06:44:17 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - manoj2s

Pages: 1
1
Brains Development / How to use I/O from Galil 2143
« on: June 26, 2008, 03:26:48 AM »
Hi Friends

I am having Galil Controller 2143, I have downloaded Galil Plugin. Now i can run Motor using Mach3.

But i want to use I/O from Galil Controller.

Can anyone please advice how should i do it??

Regards,
Manoj

2
Galil / Mach3 + Galil DMC2133
« on: April 04, 2008, 03:03:28 AM »
Hi all,

I am having Galil DMC-2123 controller with onboard AMP 20540 drive & pittman motors. I want to use MACH3 for 2 axis truning job application where i am going to retrofit a OLD manual lath.

I have downloaded MACH3 & pluging for Galil controller, they are communicating very well but my problem is i want to configure AXIS of Galil controller with Mach3 for turn application.

For example i want to used X & Z axis for turn application how can i do it.
Please advice.

Thanks
Manoj

3
General Mach Discussion / Can i use MACH software on Turret Lath
« on: November 20, 2007, 12:16:00 AM »
Hi Friends

Can i use MACH software on Turret Lath

Regards
Manoj

4
General Mach Discussion / Problem with MACH3 Mill
« on: November 16, 2007, 01:47:08 AM »
Hi

I am using MACH3 for hobby cnc stepper motor application.

Since last time i find problem with MACH mill like i can run motor in only forward direction when use reverse direction key then only DRO is updating but motor is not moving.

Could you please advice,

Regards
Manoj

5
General Mach Discussion / Want to built 3 axis engraving
« on: October 26, 2007, 03:04:40 AM »
Hi Guys

I m new bie for CNC things.

I want to built 3 axis engraving machine to engrave name.

Can anybody pls guide me

Specification :

My object size = 750mm long / 350m wide / 200mm hight
Engrave word size (height) = 5 mm to 30mm


Regards
Manoj

6
General Mach Discussion / Please help me
« on: September 08, 2007, 01:37:49 AM »
Hi Friends,

Please help me,

For my hobby CNC project i decided to use MACH3 & stepper motor setup.

Currently i have finished my mechanical framings of Hobby CNC.

Now its time to run Stepper motor on Mach3 but facing problem to it so.
I have design bipolar stepper motor drive using L298 but when i tries
to run using Mach3 & printer port then it fails to work nothing is
happen.

I have preconfigure printer port pins as MACH3 software uses but still
not working.

Can anybody please guide how to resolve this problem.

Regards
Manoj
manoj_sakpal2000@yahoo.co.in

7
Forum suggestions and report forum problems. / Need Help
« on: July 19, 2007, 07:43:42 AM »
Hi

I am new to Mach software but we have developed our Stepper Drive  weith (Enable + Step + Direction) Input.

Can anybody guide us how to Configure this software MACH 3 for our application

Regards, Manoj

Pages: 1