Topics

1

Mach4 General Discussion / controller

« on: October 20, 2020, 08:03:15 PM »

I am presently running Mach3 and i have a Gecko controller with a parallel port hook up and would like to get away from Parallel port usage ...If i go to Mach4 is there a way to use the same controller but not use a parallel port on my PC(maybe adaptor) or do i need a new controller to get away from Parallel technology

Thanks
George

2

General Mach Discussion / spindle

« on: April 08, 2018, 07:13:55 PM »

I am new here and the spindle on my machine doesnt shut off automatically.....Is there a control pin or state pin for controlling/utilizing l spindle motor control.


Thanks
George