1
General Mach Discussion / Relay Issues
« on: May 27, 2022, 11:32:44 PM »
Utilizing Mach 3 on a cnc router. I setup a stand-alone 5-volt relay to run a 24-volt pneumatic solenoid for an air blast. I originally utilized Output 8 for controlling the relay. Initially for some strange reason, the relay was controlled off/on by the Reset button. I changed to a different Output and the issue went away and now relay works correctly.
I’m setting up another separate relay (same as first relay) and I’m having the same issue. I changed to a different Output and the Reset button triggers the relay off/ on again. I hope this is enough information for help.
Any thoughts on things I could check out?
I’m setting up another separate relay (same as first relay) and I’m having the same issue. I changed to a different Output and the Reset button triggers the relay off/ on again. I hope this is enough information for help.
Any thoughts on things I could check out?