Topics

1

General Mach Discussion / cutting to small

« on: February 16, 2019, 07:25:55 PM »

okies ill start by saying im pretty new this this stuff so be kind ive been running mach3 for about a year then ran into the port issue, got that resolved but now when i run a image thru mach3 it cuts way to small.. I.E. image is 8"X 10" cuts it like it was 1\8th inX 1/8 in..

2

General Mach Discussion / mach 3 not working?

« on: April 15, 2018, 07:30:39 PM »

hello all, I have had my machine (3040t) for about 2 months, and now when i load a file into Mach 3 in the display window you dont see the pic that is going to be made. instead you see a very small version in the box, and when the program starts is only moves the machine about an 1/8 of an inch.

this may seem very vague, and im sorry for that.. still learning

Eric

3

FAQs / tool path problems?

« on: March 09, 2018, 09:37:38 PM »

  hello all,

I just got a Chinese 3040 engraver/mill. I hook everything up, installed reg.copy of Mach 3 and imputed my g-code. however once I started running the program it would air trace the picture, and cut when it was moving to the next cut location, then rise out of the stock and start air tracing again. Im at a loss with this. If anyone can point me in the right direction great

Thanks for your time,

Eric