Hello Guest it is March 28, 2024, 04:26:59 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - gmankev

Pages: 1
1
I want to develop some customization for my router setup. So that means MACH4 with LUA or MACH3 with VB. I am unsure which and wanted to try both before comitting.

Is there a list of restrictions - I know some - 500 line limit, no THC in plasma.

Will MACH3 allow me to run VB macros without a license ?

 I tried some M6 tool changes and the pop up AskTextQuestion or msgBox to M6Start.m1s  I added do not appear to pop up .. but MACH did stop and Cycle Start button continued the program. 

I also noticed I could not add the tool change position to the GUI . 
 
I did get notified of some errors too, which I corrected - but still no execution of the VB lines.

2
Newfangled Solutions Mach3 Wizards / tiling - X only very long piece
« on: March 09, 2018, 12:40:17 PM »
I believe tiling is not supported in MACH.

I have thought about a workaround, but dont know if the basis of the idea is possible.

Is it possible to tell MACH that its at a particular very long measurement greater than its machine table. MACH would then work there in a relative manner.

Is there any way for the user to input a measurement which will tell MACH3 that when I do ref all home  its actually at 2400 mm and next time its ref all home its 4800 mm.

Pages: 1