Hello Guest it is March 29, 2024, 02:14:17 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - oldironfarmer

Pages: 1
1
Greetings!  I'm new here and eager to learn.  I have a router I bought ten years ago, never mastered g-code, gave it to my grandson, then retrieved it recently.  I'm doing Fusion360 for a 3D printer and think I can generate g-code for the router.

My router has kl23h276-30-8b motors and I'm getting it to run well, I think.  However when doing a lot of stepping the motors get hot, about 175F 80C.  Is that normal?

Also, when the router stops the motors sometimes are still making a noise, pretty low, but I have to turn the breakout board off to get them to stop, or step them manually to a different location.  Do I have a configuration problem?

Thanks in advance for any help.

Pages: 1