1
General Mach Discussion / RefAllHome issues
« on: August 13, 2018, 05:32:53 PM »
Hi
I have a couple of issues with zeroing my CNC;
1/ When i RefAllHome with the Y axis it slows down, goes to zero then Y5 & then goes the opposite direction it should go ie. away from the home switch... forever(?)
If i change the motor tuning acceleration to 80 (from 400) it works as it should- but it's frustrating having to do this & back again every time.
2/ When i run G28.1 X10Y10Z10 from MDI it works fine. When i put this into a gcode & run it repeats itself over & over - is there a way to tell it to stop?
Cheers
I have a couple of issues with zeroing my CNC;
1/ When i RefAllHome with the Y axis it slows down, goes to zero then Y5 & then goes the opposite direction it should go ie. away from the home switch... forever(?)
If i change the motor tuning acceleration to 80 (from 400) it works as it should- but it's frustrating having to do this & back again every time.
2/ When i run G28.1 X10Y10Z10 from MDI it works fine. When i put this into a gcode & run it repeats itself over & over - is there a way to tell it to stop?
Cheers