1
General Mach Discussion / Z stop errors
« on: February 28, 2018, 09:23:16 PM »
Hi all -
I built a gatton cnc. All good. My Z home, ++ and -- were working fine, then I kept getting resets. I figured it was the z-- and z++ because when I shut them off all good. I check the wiring no issues and when I toggle the limit switches I do get the yellow flash on the diag screen with the home switch. I have the switches in series with active low X, so its hot 5v. I must have toggled something else I am thinking for this to happen, anyone have any ideas?
My x and Y are fine.
Thanks
John
I built a gatton cnc. All good. My Z home, ++ and -- were working fine, then I kept getting resets. I figured it was the z-- and z++ because when I shut them off all good. I check the wiring no issues and when I toggle the limit switches I do get the yellow flash on the diag screen with the home switch. I have the switches in series with active low X, so its hot 5v. I must have toggled something else I am thinking for this to happen, anyone have any ideas?
My x and Y are fine.
Thanks
John