1
Mach4 General Discussion / Tormach moved from Mach 3 to Mach 4 - Feedrates 2X what is requested
« on: January 28, 2018, 06:30:22 PM »
Hello,
I recently moved my Tormach 1100 from Mach3 to Mach4 and my feedrates are 2X what is commanded (i.e. F20 shows as 40 on the screen), and one snapped endmill later while watching my program haul hiney I believe what the DRO is showing.
Running Mach4 Hobby and ESS combination.
I was very careful to copy the settings from my Mach3 profile and I don't see anything obvious.
I have not looked too deeply at this yet, but I figure I'm not the first to see this.
Any advice where to look first?
In the meantime, I just halved my rates in my CAM setup...
Thanks,
Danny Brija
I recently moved my Tormach 1100 from Mach3 to Mach4 and my feedrates are 2X what is commanded (i.e. F20 shows as 40 on the screen), and one snapped endmill later while watching my program haul hiney I believe what the DRO is showing.
Running Mach4 Hobby and ESS combination.
I was very careful to copy the settings from my Mach3 profile and I don't see anything obvious.
I have not looked too deeply at this yet, but I figure I'm not the first to see this.
Any advice where to look first?
In the meantime, I just halved my rates in my CAM setup...
Thanks,
Danny Brija