Hello Guest it is October 20, 2021, 05:14:27 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bobbas41

Pages: 1
1
General Mach Discussion / Mach 3 struggling with fusion360
« on: January 18, 2018, 11:28:52 PM »
Hi guys, so I have a bridgeport mill with gecko drives and it runs mach 3 for the control. It seems like Mach is struggling to process the adaptive strategies produced from fusion 360. Wondering if any of you have seen the before, the mill acts like its starving for data and so it makes jerky movements as it processes each block of code, on more simple countours and stuff it does fine, it just does this with the adaptives?
Any thoughts?

Pages: 1