Hello Guest it is December 07, 2021, 12:15:49 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - wisconsinjimmy

Pages: 1
1
General Mach Discussion / Limit Switches Hard and Soft
« on: February 22, 2018, 03:27:05 PM »
Hello all,
I have my Hard Limit Switches glued to the chassis and wired in series and when any of the limit switches are contacted the machine stops. X travel is 50.0000mm and my Y travel is 60.0000mm these numbers are when the machine just moves the switch.
Now how do I set the soft limits? On the X travel do I start at 50.0000 mm enter this in max and 00.0000 in min and hit enter.

Best Regards and God Bless
Jim G
Cushing, WI

2
General Mach Discussion / G90/G91 State Abnormal Condition
« on: February 07, 2018, 10:09:00 AM »
I am so new at this one hell of a learning curve, My one motor on the Y AXIS is what I call binding I can turn it to the + just so far and it stops. same for the - AXIS then I get a Code G90, G91 State , also when I turn the controller on the Y motor makes a loud banging noise ( just once). I have removed the motor as I needed to know if the motor was at fault for grinding to a halt or is it the NuT and screw jamming which they are not.
Thanks for the help
Jim

Pages: 1