Hello Guest it is August 14, 2020, 02:18:48 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Tuffluck Designs

Pages: 1
1
General Mach Discussion / Code stops at line 488
« on: January 06, 2018, 09:25:20 PM »
I'm ramping down to a depth on a slot and the code repeats x and y after line 488. I checked the flash drive I'm using and the code is all there. Also tried a different flash drive and the same result. Also tried reprogrammed only one of the three slots and also the same thing.


Sent from my XT1650 using Tapatalk

Pages: 1