Guest
Show Posts
1
General Mach Discussion / Omio X8-2200L-USB doesn't work
« on: December 30, 2017, 04:50:30 PM »
I purchased a Omio X8-2200L-USB some weeks ago and can't get it working. I have installed Mach as described in the manual, everything is correct connected, control box is alive but nothing moves. The steppers locks but I can't get them to move at all. Tried to uninstall Mach, remove the folder and install again, then install on my co-worker's private laptop and it also failed. The first was with Windows 10 64-bit and USB 2.0, the other Windows 7 64-bit also with USB 2.0.
Then I installed it on my laptop - and it worked, this one has Windows 10 64-bit. This is my private computer I need for other purposes.
The first computer was used for my old CNC machine and was a little obsolete so I scraped it and bought a new (but used) computer. Reinstalled Windows 7 (64-bit), no other programs and installed Mach again. Unfortunatelly it didn't work - I have tried to uninstall and reinstall Mach without success. And I have followed Omio's guide and I am pretty sure I've got it right.
Any suggestions?
Then I installed it on my laptop - and it worked, this one has Windows 10 64-bit. This is my private computer I need for other purposes.
The first computer was used for my old CNC machine and was a little obsolete so I scraped it and bought a new (but used) computer. Reinstalled Windows 7 (64-bit), no other programs and installed Mach again. Unfortunatelly it didn't work - I have tried to uninstall and reinstall Mach without success. And I have followed Omio's guide and I am pretty sure I've got it right.
Any suggestions?