1
General Mach Discussion / No deceleration on surfboard chatting
« on: December 20, 2017, 12:03:21 PM »
Good day all
I'm making surfboards designing and exporting G code from Shape3D and then running the G code in Mach3.
I've set my deceleration in Mach3 but when it comes to the end of my board, it stops dead with no deceleration.
Is it possible that Shape3D is dictating that or is there something I can adjust on Mach3?
Cheers!
I'm making surfboards designing and exporting G code from Shape3D and then running the G code in Mach3.
I've set my deceleration in Mach3 but when it comes to the end of my board, it stops dead with no deceleration.
Is it possible that Shape3D is dictating that or is there something I can adjust on Mach3?
Cheers!