Hello Guest it is May 07, 2021, 05:22:33 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Tona

Pages: 1
1
General Mach Discussion / Cutting points instead of line
« on: December 13, 2017, 01:43:20 PM »
Hello,

I have a plasma CNC and I'm trying to cut a simple path (a square), the problem is that the CNC is cutting points instead of a line.

I'm new using Mach3 but I think that it might be a software configuration problem because in the drawing I see the cut path as a line, the machine follows the path but instead of cutting a line it only makes points.



Link to a picture of the points.
https://imgur.com/8jbI11w

Pages: 1