1
General Mach Discussion / Dolphin v10 post processors
« on: September 19, 2018, 06:43:40 AM »
Can anyone help with copies of post processors for Dolphin v10 (I think v11 & v12 work)
Dolphin's post processors pages are not working! (Mill links are NOT FOUND) and lathe are DEAD.
I's lathe that I need most, but I should like to have mill also. (For Mach3)
If anyone has tips on using this software with Mach3, That would be great as I am new to lathe work.
Dolphin's post processors pages are not working! (Mill links are NOT FOUND) and lathe are DEAD.
I's lathe that I need most, but I should like to have mill also. (For Mach3)
If anyone has tips on using this software with Mach3, That would be great as I am new to lathe work.