Hello Guest it is December 07, 2021, 01:03:41 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mraman21

Pages: 1
1
General Mach Discussion / Can't Get Spindle To Turn On
« on: November 30, 2017, 01:58:31 PM »
Hi, I'm Max and I am new to the Mach community. I see a lot of topics posted here about people not being able to get the spindle to work. I have read through about a million things about ports & pins and have tried thousands of different variations of port & pin configuration. I purchased my machine off of eBay; 6040z 4-Axis CNC engraver with a Yoocnc M3-USB-JB4 (V04) motion control card equipped. The Machine came with a version of Mach3 on a disc and later found out that is was pirated. So I went and purchased a clean version of the software hoping that would magically solve my spindle issue, but unfortunately I am still stuck in the same mud pit. Anyway, I'm hoping that someone can help me out here so I can start making chips.  :'(

Attached is a copy of my XML file.

Thanks in advanced

Pages: 1