Hello Guest it is November 19, 2019, 11:10:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bobwelder

Pages: 1
1
Mach4 General Discussion / Mach 4 THC
« on: May 24, 2018, 02:16:38 AM »
Hi Everyone
I have a proma THC and it works really well under mach3, however I want to use mach4 due to the fact that it is maintained. Also this Windows upgrade issue.
I have the leds showing that the THC is sending the signal through the UC100. The UC100 diag is showing the signal, so why is the Z axis not moving?
Any help would be great.

Many thanks
R

2
FAQs / Z Axis and machine coords
« on: November 06, 2017, 01:54:48 AM »
I've hunted high and low for an answer to this.
I'm trying to use scripting to set up floating torch for my plasma (Hypertherm 45) Now the problem I'm having appears to be an odd one. When trying to read the position of the z axis from the machine coords it reads 0 yet the working coords are reading the correct values. The machine works brilliantly but Mach 3 seems to be ignoring the z axis coords
Please help
Many thanks in advance
Rob

Pages: 1