Topics

1

General Mach Discussion / unable to ref all home

« on: March 12, 2019, 03:30:38 PM »

Hey looking for some help here and think its pretty simple fix, i hope!!!
getting a message" requested home axis home switch is active please fix then home" how do i fix?
when in ref all home my dros go to zero my machine stays put. Working on day 2 of frustration.Please help

2

General Mach Discussion / Where am I?

« on: March 11, 2019, 08:17:15 AM »

Through Manual travel all limit switches set fine. home is front left corner fine. when i travel from home into cutting are all dros read negative numbers how do I reverse the polarity of these, making them positive and know where to cut?

3

General Mach Discussion / Parameters seem off

« on: November 01, 2017, 07:32:50 AM »

Hello everybody I'm trying to create a SOP for our cnc. When Vcarve is loaded to the Mach3 software the artwork appears off the table in the display window. I am hoping  to learn proper way to configure and save settings for the Motors, Home, Softlimits, The DRo to show actual units that match movement and spindle operation from the software not manual
Pleas Help
 Thanks Brian