1
Mach4 General Discussion / mcCvTuningWizard
« on: October 29, 2017, 10:14:25 PM »
I was having issues with rounding off corners as my feed rate went above 150. Looks like I need to set up my CV feeds. After I ran the mcCvTuningWizard and checked the CvTuningWizard it had filled in the feeds. So I tested the path and it was still too fast. I changed the mcCvTuningWizard setting and it will not update the table in CvTuningWizard.
Is there a way to reset the CvTuningWizard back to 0.000 for all angles? Setting 90 lines back to 0 one at a time doesn't seem right. Plus even if I do the mcCvTuningWizard keeps putting it back to my first settings.
If all I want to do is slow down on the hard angles should I even be using mcCvTuningWizard? What are the recommended numbers for a router?
Is there a way to reset the CvTuningWizard back to 0.000 for all angles? Setting 90 lines back to 0 one at a time doesn't seem right. Plus even if I do the mcCvTuningWizard keeps putting it back to my first settings.
If all I want to do is slow down on the hard angles should I even be using mcCvTuningWizard? What are the recommended numbers for a router?