1
General Mach Discussion / Stepper motors
« on: October 13, 2017, 07:59:47 PM »
Hi Guys
Having some trouble with random missing steps, my machine stops code continues to run in Mach 3 then machine goes again obviously in the wrong place due to the stop. Motors sometimes stall when I jog so I'm thinking it may be set wrong somewhere, I am hoping someone is able to tell me what my settings should be.
my machine info is
1600 steps
8 micro steps
15 motor teeth
leadscrew 30
leadscrew pitch 2mm
hope this makes sense to somebody. Its on a fully licensedmach 3 copy (to me). Thanks
Having some trouble with random missing steps, my machine stops code continues to run in Mach 3 then machine goes again obviously in the wrong place due to the stop. Motors sometimes stall when I jog so I'm thinking it may be set wrong somewhere, I am hoping someone is able to tell me what my settings should be.
my machine info is
1600 steps
8 micro steps
15 motor teeth
leadscrew 30
leadscrew pitch 2mm
hope this makes sense to somebody. Its on a fully licensedmach 3 copy (to me). Thanks