Hello Guest it is March 29, 2024, 10:47:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Alchartier

Pages: 1
1
General Mach Discussion / MPG Deceleration issue
« on: October 09, 2017, 01:57:42 PM »
My customer is running Mach3 with a Galil DC4153, and iMach P3A pendant, and 2 surestep servos.  When using the pendant to manually move an axis, the motion continues an excessive amouint after the operator stops rotating the dial.  Is this deceleration time/dist controlled by MAch3, the controller, or the pendant? 
A little more info if it helps: The original XP computer that ran the system died. They installed another XP computer and copied files over and have been struggling to get it all back to the original condition. 
Any help is appreciated as they are down.

Thanks.

Pages: 1