1
General Mach Discussion / Tangential arcs
« on: December 08, 2011, 03:54:58 AM »
Hello everyone,
Can anyone help please, I have mach3 driving a Homann MB-02V6 breakout board and gecko 203V's
When cutting tangential arcs or compound curves the motor stops or stall between each arc and I
cant get the motors to move linearly.
Is there a setting I have missed?
Can anyone help please, I have mach3 driving a Homann MB-02V6 breakout board and gecko 203V's
When cutting tangential arcs or compound curves the motor stops or stall between each arc and I
cant get the motors to move linearly.
Is there a setting I have missed?