Guest
Show Posts
1
General Mach Discussion / Reference not stopping
« on: September 23, 2017, 01:28:15 AM »
Hi,
My problem is that the reference all home works till the z- axes go to the home switch, as felling the sensor, the movement change to the other direction and then the axes don't stop. If I make this to the other axes the same result.
This was happened as I change the controller leaveboy 77 and the y-sensor .
Thank you for your help.
My problem is that the reference all home works till the z- axes go to the home switch, as felling the sensor, the movement change to the other direction and then the axes don't stop. If I make this to the other axes the same result.
This was happened as I change the controller leaveboy 77 and the y-sensor .
Thank you for your help.