1
General Mach Discussion / KX1 with Mach3 not talking to computer
« on: September 22, 2017, 09:13:10 PM »
Hello
We have a KX1 with Mach3.
Have taken advise from Tweakie.cnc Downloaded and installed Mach3 and extract file from Mach3.xml and attached zip folder. All the motor and ports & pin file is there.
Now when we try to contact the mill through key board to move X Y Z there is only a chick noise from mill and no movement.
Does any one know what may be wrong?
Cheers
Aussie John
We have a KX1 with Mach3.
Have taken advise from Tweakie.cnc Downloaded and installed Mach3 and extract file from Mach3.xml and attached zip folder. All the motor and ports & pin file is there.
Now when we try to contact the mill through key board to move X Y Z there is only a chick noise from mill and no movement.
Does any one know what may be wrong?
Cheers
Aussie John