Topics

1

General Mach Discussion / Coordinates

« on: October 03, 2017, 11:18:57 AM »

Please could someone assist me with setting up my machine and job coordinates... everytime i run a wizard in mach3 it runs into a endstop before it gets to the job toolpath

Thanx
MAV

Sent from my SM-G900H using Tapatalk

2

General Mach Discussion / Interference with axis motors

« on: September 18, 2017, 04:12:02 PM »

Hi all i purchased a CNCMASTERS CNC JR.  Through a auction a few monthes ago the previous owner did a mach3 conversion on it but still working on the standard hardware and drives.

I have got the axis motors to work and the spindle issue is using them together. As soon as the spindel starts the axis motors goes haywire. But as soon as the spinde motor is off and the cnc jr. Is restarted the axis works fine till the spinle goes on again.

Hardware
Pc with win 10 64bit
Mach3 board and mach3mill software
Standard cnc jr. Motors and drivers
Speedmaster sm vfd
 
Kind regards
MAV

Sent from my SM-G900H using Tapatalk