Topics

1

General Mach Discussion / HELP MACH3

« on: May 01, 2018, 04:01:07 PM »

Good afternoon:
I want to know how to implement a turret for tool change in mach3 and how many servomotors I can control. Also if the codes G70, G71, G72, G73, G74, G75, G76 can be used.

2

General Mach Discussion / HELP WITH MACH3TURN

« on: December 17, 2017, 11:18:43 PM »

Someone has information about what can and can not be done with a trial version of mach3 for lathe, please if someone has a mach3 turn license for students that can provide me, it would help me a lot, or information about how this and where can I buy it?

3

General Mach Discussion / Help spindle speed

« on: November 13, 2017, 03:55:47 PM »

Good afternoon, buy the following card to be able to drive a motor with encoder, but I can not make the mach3 regulate the rpm with this card, you could help me with this problem, since I do not know what it is, if that is why I have badly configured mach3 or badly connected the card.
Annex the papers.

4

General Mach Discussion / help whit signal step

« on: September 17, 2017, 10:35:39 PM »

I have problems with my CNC router, when checking the output signals of the LTP port I realize that when I move the motors of the axes, the signal indicates in which direction it has to rotate if it is activated but never stops sending output signal (the step) is never going to low.
I could help verify what is due, whether it is setup on the mach or is normal.
thanks for your help