Guest
Show Posts
1
General Mach Discussion / IS THERE ANY WAY TO JOG AROUND BOUNDARIES OF GCODE IN MACH3
« on: September 14, 2017, 07:14:46 AM »
Hi everyone,
I am facing a little problem in aligning the material because of its complex shape, Question is that IS THERE ANY WAY TO JOG AROUND BOUNDARIES OF GCODE IN MACH3 ?
Added info below from other the other post he made that I deleted: RICH 9/14/2017
I am facing a little problem in aligning the material because of its complex shape, Question is that IS THERE ANY WAY TO JOG AROUND BOUNDARIES OF GCODE IN MACH3 ?
Added info below from other the other post he made that I deleted: RICH 9/14/2017
Quote
Hi everyone,
Can Mach3 jog around the boundaries of gcode with a command, Not manually, This is because i often have complex shaped materials to be carved, And the alignment of my job is really a hard job for me, I was wondering that there would be an option in mach3 that let me trace the boundary on my material, So that i can be sure that is my material placed well or not,