1
Galil / No DRO readings with Mach 3 and GALIL DMC-1740
« on: September 12, 2017, 12:41:47 PM »
For approximately 15 years I used a program called WinGCNC with a Galil DMC-1740 controller. All was good. Recently my computer crashed and I have been unable to locate my backup copy of the WinGCNC program. I purchased Mach3 and the Galil plugin. I can get the program to recognize the Galil card but I have no DRO readouts. If I energize the servos, the table moves in a negative Y direction until it contacts the limit switch but still with out DRO readings. This is on a Bridgeport Series I with 3 axis servo motors. I have tried different config settings without success and am out of ideas. Has anybody had a similar experience?