Hello Guest it is March 29, 2024, 06:09:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Deimosjuf85

Pages: 1
1
General Mach Discussion / Thrading on mach 3 with ss and c10 bob
« on: September 02, 2017, 01:39:18 PM »
Best regardsI have a 7x12 mini lathe with warp9 Ethernet SmoothStepper, c10 bob , c3 idex pulse card , two  Stepper Motors 570 Oz-in, Nema 23, I have mach 3  3.043.062 and a disk with one slot for index.When i try to cut threads no matter wich pitch i put on the g code the machine cut the same pitch  no matter the value that i put  in the index debounce the machine cut the same pitch. Can you help me to setup the mach 3 nad the hardware that i have? Sorry for my bad english

Pages: 1