1
General Mach Discussion / Moving settings to another computer
« on: September 18, 2017, 10:11:32 PM »
I'm sorry as I'm sure this has been asked before but my searching skills are very poor. I have Mach3 (demo mode, running the lathe program only at this time) set up and operational on a Windows 10 laptop and I want to see if an old Windows 7 netbook will run it. I found a thread that says to copy the XML file from the old to the new computer. I've done that but when I start Mach3, it's showing the default settings. I am certain I'm doing something wrong...obviously. Can anyone help?