Hello Guest it is September 21, 2019, 02:02:32 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ron from nj

Pages: 1
1
I'm *********ed,..... ok got that out of the way.
I have mach3 i have a romaxxcnc system.  They i think sell these table tops to people with
a lot more experience than me. which is none.

They said it was easy, takes a little setup ete etc...

I have a goal, i need to make very small molds, flate plates say 8" x 5" x 1/2" thick in the
middle i need a area to mold the is about 1/8" inch the shape of an underwire. i have the
plastic injection machine, new 40 amp power source, air compressor 100 gallon air cap.
led lighting all set up in a trailer ready to go.  My dreams are small i just want to make a
fricken plate. but i am lost. i need someone to come in, look at the drawings, see what i
am up to and teach me hands on and most likely one other person.  I am in trouble here
i have a patent finally- but this is a huge issue for me.... if anyone is in this area please.
I am willing to pay I am not even sure this is the right forum, i couldn't find how to start
a new thread to ask, my apologies if this is in the wrong place.
Ron.
 sixtyninejets@yahoo.com  

Pages: 1