Hello Guest it is September 21, 2020, 10:10:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - rick2017

Pages: 1
General Mach Discussion / RijK words all missing
« on: August 24, 2017, 06:29:27 AM »
Hi all.

I am a newbie  I did search the site but found nothing relevant. So please bear with me.

I am running mach3 on an XP system. On some G code files, (not all), containing curves I get an error message

RijK words all missing arclinexx.
 xx varies file to file. And Mach3 obviously  does not display the paths or run the file.

Have I something wrongly set in Mach3 setup or is it just a G code creation error of some sort.


Pages: 1