Hello Guest it is April 24, 2024, 05:05:02 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - HM78

Pages: 1
1
CS-Lab / CSMIO/IPS MACH4 "Counts per unit"/DRO Problem
« on: July 16, 2017, 05:16:10 PM »
My problem is with the motor tuning. I physically jog the machine 100mm and the DRO in Mach4 will show 160mm for example. Normally this could easily be corrected by adjusting the "counts per unit" under motor tuning in Mach4, but unfortunately that has no effect! Any value entered in "Counts per unit" is completely ignored. I have been running my machine with a pokeys57cnc controller until now and have never had this problem before. CS-Labs support has been useless at best. What seems to be the problem here?

Pages: 1