Topics

1

General Mach Discussion / Mach3 S## command delay

« on: July 26, 2017, 09:13:36 AM »

Hello all ,
I'm using mach3 to control laser machine ( tube)
But I've problem with s command , causes delay while engraving
Can I make make3 ignore that delay with S command ?

2

General Mach Discussion / lazycam postprocessor

« on: July 23, 2017, 09:50:32 PM »

Hello all ,
i want lazy cam post processor for laser cutter/engraver that works with m10px/m11px and can control power s### and feed rate

3

General Mach Discussion / mach3 with arduino

« on: July 13, 2017, 03:29:12 PM »

Hello all
I'm making laser machine with Mach3
I want to control laser pwm with an arduino and motors with parallel port to make cutting and raster but I don't know how
Can anyone help ?

4

General Mach Discussion / mach3 laser

« on: July 04, 2017, 07:21:08 PM »

Hello all
this is my first post here and I've little experience in mach3
I'm making CO2 laser machine and now I've XY table moving correctly with mach3 and parallel port
but I want to configure it to work with laser and I don't know how to set pwm pin to engrave photos and cut dxf
sorry for my bad english
Thnx