Hello Guest it is January 29, 2023, 04:42:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - lesbright

Pages: 1
1
General Mach Discussion / Mach3 Mill and CNC JR
« on: July 10, 2007, 06:18:45 PM »
I have a older CNC JR that runs on DOS and has an AC Tech motor control.
The Driver boards have been back to the factory twice and still don't work correctly.
I am interested in replacing the driver boards and running Mach3 Mill.
Possibly Gecko G100. Can anyone offer any suggestions of other driver boards. I
watched some Mach3 videos and they were down loading firmware to flash the controls.
Where I am working there will not be Internet access.
Thanks for you time.
Leslie A. Bright

Pages: 1