1
General Mach Discussion / CNC 8060Z
« on: June 06, 2017, 09:52:29 AM »
Hello all,
The company I work for bought a CNC 8060Z CNC machine from ebay. It uses USB 2.0 for the controller to computer connection. Mach 3 is what it uses. I have seen plenty of discussions about USB controllers/boards, but absolutely nothing about these china controllers that support USB, everything is parallel port it seems.
When I go to jog my axis motors via arrow keys or the pendent, they do not move. I have run this on two computers running 64 bit windows 10 (maybe that's why?) so far. I have set my ports and pins to the same that most people have. Spindle works fine.
Is there a separate USB driver required for this?
Pictures here : https://drive.google.com/drive/folders/0B6gzpeTme6nOVk9IRHY2RGpRdmM?usp=sharing
Thank you,
Joe P.
The company I work for bought a CNC 8060Z CNC machine from ebay. It uses USB 2.0 for the controller to computer connection. Mach 3 is what it uses. I have seen plenty of discussions about USB controllers/boards, but absolutely nothing about these china controllers that support USB, everything is parallel port it seems.
When I go to jog my axis motors via arrow keys or the pendent, they do not move. I have run this on two computers running 64 bit windows 10 (maybe that's why?) so far. I have set my ports and pins to the same that most people have. Spindle works fine.
Is there a separate USB driver required for this?
Pictures here : https://drive.google.com/drive/folders/0B6gzpeTme6nOVk9IRHY2RGpRdmM?usp=sharing
Thank you,
Joe P.