Hello Guest it is March 29, 2024, 11:09:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - clavijin

Pages: 1
1
HiCON Motion Controller / Mach4 - hicon pn7766 - an0, an1 in J6
« on: July 10, 2017, 02:41:09 AM »
Hi everyone

I need to gather information to input analog on hicon an0 and an1 in mach4

I have been reading and only found that the J6 pin need Hicon-adc, but I do not know how to access those data from mach4

Can anybody help me?

Thanks in advance, Raúl

2
Mach4 General Discussion / Mach4 - hicon pn7766 - an0, an1 in J6
« on: July 07, 2017, 04:06:07 AM »
Hi everyone

I need to gather information to input analog on hicon an0 and an1 in mach4

I have been reading and only found that the J6 pin need Hicon-adc, but I do not know how to access those data from mach4

Can anybody help me?

Thanks in advance, Raúl

3
Hello everyone,

I have been reading and I can not find a solution to my problem

I'm working with Mach4 and hicon integra pn7766.

I need to connect a mach4 (running on a virtual machine) with one hicon integra pn7766.

I used the VSI device manager and if I put the same IP address on the network card of the host in the host and  in the virtual machine I can see the card, but when I try to access it I get an error:

Vsi device manager error. Device went missing

Is it possible to perform an execution by communicating with the card from a virtual machine?

Sorry for my english and thank you very much in advance

Pages: 1