Hello Guest it is August 11, 2020, 02:29:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - basileul

Pages: 1
1
General Mach Discussion / THC Mode button
« on: May 24, 2017, 01:03:51 AM »
I have a CNC in a bad state and I try to make it functional. I did not work with Mach3 and only for a few days I try to understand it.
That's why I apologize for too naive questions. In the torch section of the screen there is a THC button that should light green if I want to switch to THC mode but I cannot do that. What conditions are not active?
Thanks

2
Hello,
When I changed the communication to USB, using the UC300, I can not move the axes with the arrow keys on the keyboard and I can not jog with the buttons on the screen. I noticed that if I hold the shift key pressed then the arrows and jog on the screen work just like when I was communicating on LPT and wanted to move quickly. How can I set up the keys as before using USB

Pages: 1