1
Mach4 General Discussion / Reference all axes (Home) on a machine without limit switches
« on: May 27, 2017, 07:23:20 AM »
When jogging to the "home" position and pressing the [Reference all] button, machine coordinates does not reset to zero. Why?
In homing/Linits the [In place] is checked. All limit switches are disabled in my PoKeys plug-in and in Mach config.
In Mach3 there was an "Auto Zero" option to make this happen but this is not present in Mach4.
Any suggestions?
In homing/Linits the [In place] is checked. All limit switches are disabled in my PoKeys plug-in and in Mach config.
In Mach3 there was an "Auto Zero" option to make this happen but this is not present in Mach4.
Any suggestions?